AmateurRadio.com

Results from the RAC 2021 Survey

What modes of transmission are used in various amateur radio bands? We are aware of the stalwarts of SSB or CW on HF, FM on two meters, and so forth. But some still use AM and there’s the various digital modes, like the venerable RTTY. The weak signal modes implemented under the WSJT-X software (FT8 etc.) have seemed to exploded on the bands. But where? And in what share of reported use by amateur operators?

In this article, I present some of the reported modulation modes used in specific groups of bands for Canadian amateur operators. The mode distribution by band is shown in a pie chart with the percent usage for each band. (Click on the graphic for a larger image.) This allows the reader to quickly identify where a specific mode is used and how diverse modes are for a given band allocation. This depiction does not show how much a mode is used in terms of time, only how the mode’s reported use is distributed across bands.

As a convenience to readers, I have reproduced the bar graph illustrating the percent of Canadian hams reporting the use of each band in an appendix below for quick reference.

In Figure 1, AM and SSB modulation find their traditional bands. One half of the AM use resides in the 80- to 10-meter bands. It is used to a lesser extent in 160-meters, 2-meters and 6-meters with sparse usage in the remaining band allocations. There are contests organized around two meters which may well create some of that use as well as SOTA and related operations. The Magic Band of six meters is open for distance seasonally and sporadically within and outside that season. The use there is likely predicated on the propagation eccentricities of six meters. The microwave bands have small use of AM. Recalling the smaller segment of hams operating in these bands (see appendix), this use may be ardently deployed by a smaller number of active amateurs there.

The use of single sideband usage is unsurprisingly dominated by the 80-10 meter HF bands with six meters coming in a distant second. The six meter and 160 meter bands come in next at 19 and 14 percent, respectively. This is followed closely by two meters (13%). These figures tend to decline sequentially as the frequency band increases. SSB is a frequently used mode, largely in frequency bands that are fairly known to active ham operators.

Turning to the use of CW, it is an original mode for the radio amateur. There are many, many debates as to the status of how much Morse Code is used on the ham bands today. For the first time, this national survey documents both how many hams say they use CW (32%) and where they use it as shown here in this article. As displayed in Figure 2, CW is used in several bands, dominated by HF (80-10 meters) at just over one-third (35%). Two bands bookending HF finds CW a common mode: 160- and 6-meters. This mode’s usage drops off precipitously in the 70cm band, 900 MHz, and 10 GHz bands. These are followed by the 1.2 GHz band with the rest having nominal CW activity reported in this survey.

These national survey results should serve as a benchmark—along with the share of hams reporting the use of CW in the appendix—for future discussions of the status of CW operations, at least in Canada.

The rise of digital data modes (especially the wildly popular FT8) is confirmed in this national survey of hams. Some inferences can be made using signal spots (like PSKreporter) of specific transmissions and reception circuits but they do not represent the broad population of all ham operators, only signals over a transient period. The HF bands, from 80 to 10-meters, are used with digital data modes by over one-third (35%). This is followed by 6 meters (15%) and 160-meters (12%) as well as 2-meters (12%). There is nominal to significant digital data mode use on the rest of these band allocations as well. The 70cm band has, for instance, 6 percent of these amateurs using digital data modes there. Thus, digital data modes are a significant means of communicating in most all of the amateur band allocations for Canada. While HF and nearby frequencies are the prominent areas, it is only 24 GHz that show no reported digital data mode activity as of 2021.

The uses of a modern digital voice mode as well as a traditional data mode, RTTY, are summarized in Figure 3. It is no surprise to the reader who is active on 2 meter and 70cm repeaters that some 85 percent of the relative digital voice usage across bands is concentrated here. The 2-meter band has 44% while the 70cm band has 41% of digital voice use in Canada. The rest reflect nominal patterns, such as the 4 percent with digital voice operations in the 6-meter segment. These specific digital modes (DStar, etc.) are not broken out separately in this survey. The picture of where digital voice modes are used is rather clear in these results.

The traditional data mode of RTTY remains largely an HF-centered transmission style. The 80- to 10-meter bands garner almost three-fourths (71%) with the 160-meter band trailing far behind in second place at 15 percent. The remainder trail off as the frequency goes up the spectrum. RTTY is still used, perhaps during RTTY-allowed contests, but it is used almost wholly on HF and 160 meters.

The final transmission mode presented in this article is slow-scan television (SSTV). Figure 4 contains these results. Like RTTY, it’s largely an HF use pattern (52%). However, for SSTV, two meters has almost a third (31%) of the traffic in this mode. The 70cm band follows (8%) with six-meters right behind (6%). The 1.2 GHz band, gaining in popularity due to more commercial equipment being available, is used by 1 percent. The other slivers in this pie chart round down to zero percent but it does reflect small numbers of microwave-oriented ham operators making use of the spectrum. Will that grow? It will take another replication of this survey a few years in the future to determine if that prospective growth is measurable in such a broad survey like this.

Conclusions

Transmission modes in Canada largely conform to what many readers would expect for the traditional modes of SSB and AM. CW use may be somewhat surprising but should be compared to the prevalence of CW usage by Canadian operators (see appendix). The use of digital voice and data modes is much more diverse in some ways. Digital voice has taken flight on both repeaters but particularly the small, inexpensive “hotspots” that operate via the Internet to connect local operators to other repeater systems worldwide. Digital data modes have exploded through the proliferation of the WSJT-X software and it’s variants. Many hams in the public sphere decry the use of, for instance, FT8, over using voice or CW modes. However, it has made many bands more active as can be seen by others analyzing the online databases of observations such as WSPR, PSKReporter, and the RBN sites. Such is how behavioral change occurs in large, moderately organized groups like amateur radio. It is the collective behavior that shapes the usage of a technological innovation like weak-signal modes and such.

My overall assessment of these results is that the Canadian ham bands are both stable, in the main, and innovating in some frequency bands. I say this partly because the microwave regions have a pluralistic set of modes in use today. This is undoubtedly the result of experimentation as well as competitive contesting or DXing activities. The combination of modes plays well into the future growth of both the operational efficiency as well as the market development for commercial products. The recent release by Icom of their IC-905 transceiver is a case in point.

I hasten to note this. Some readers will invariably say, “But I don’t see that [result]…” Sure, an individual ham operator’s observations either on the bands or elsewhere are a relatively unique way of gathering observations. They are not consistent across observations as people look at the world in differing ways. And, they do not garner insight into a collective national view of what is consistently obtained in a large-scale survey such as that for the RAC Survey 2021. Please bear that in mind with regard to these results as you read them.

Appendix: Band Usage Bar Chart from Full Report