Commemorating 80 years 

An important stage in the liberation of Western Europe

Operation Market Garden was an Allied military operation during the Second World War fought in the German-occupied Netherlands from 17 to 25 September 1944. Its objective was to create a 103 km salient into German territory with a bridgehead over the Nederrijn (Lower Rhine River), creating an Allied invasion route into northern Germany. This was to be achieved by two sub-operations: seizing nine bridges with combined US and British airborne forces (´Market´) followed by British land forces swiftly following over the bridges (´Garden´).

The airborne operation was undertaken by the First Allied Airborne Army with the land operation by XXX Corps of the British Second Army. The airborne soldiers, numbering more than 41,000, were dropped at sites where they could capture key bridges and hold the terrain until the land forces arrived. The land forces consisted of ten armoured and motorised brigades with a similar number of soldiers. The land forces advanced from the south along a single road surrounded by flood plain on both sides. The plan anticipated that they would cover the 103 km from their start to the bridge across the Rhine in 48 hours. About 100,000 German soldiers were in the vicinity to oppose the allied offensive. It was the largest airborne operation of the war up to that point (Wikipedia ©). Perhaps the most famous, after D-Day, in the history of the Second World War.

As part of Operation Market Garden paratroopers of the Allied forces, such as American, British, Canadian, Polish and Dutch troops, landed in the Nijmegen region on 17 September 1944. The region became a battlefield during Operation Market Garden and most of the inhabitants took refuge in the woods or neighbouring towns. It took more than a week of heavy fighting before parts of the region were temporarily liberated. Many people and military were killed and buildings and bridges were destroyed. At the cost of many young soldiers the important Waal-bridge in Nijmegen was conquered. In our collective mind the entire region was completely liberated in 1944, but this was only for a period of three weeks. There was still hard fighting during the winter and complete liberation was not achieved until may 1945.

YouTube video: Operation Market Garden

The special event

From September 13 to 19 a special event station will be operating in the Nijmegen region of the Netherlands commemorating 8Ø years of freedom. The callsign is PA8ØOMG.

During 7 days they will activate the callsign PA8ØOMG and work amateur radio operators across the world. If you find yourself in the vicinity of Groesbeek and Nijmegen, be sure to visit us throughout the activities of the special event station. We are situated at one of the exact landing grounds of the 82nd Airborne division in 1944. Our website https://radioclublimburg.nl/pa80omg/index.html

~

This livestream recording is from September 1, 2024 – the NW7US Radio Communications Channel Livestream.  We do this livestream every Sunday at 21:15 UTC.  Here is the link to the livestream from this past Sunday:

The livestream list is here:

https://www.youtube.com/@nw7us/streams

I hope to see you in our livestream live chat, during the next session on Sunday, at 21:15 UTC.  See you there!

This ground rod took forever to pound in.

I had the opportunity in the spring to pick up free of charge 2 copper-clad 8-foot ground rods free of charge as long as I picked them up. It was about an hour's drive for me but free ground rods were well worth the trip. Also, I was able to meet one of the hams from our contest club and have a coffee and a nice chat. As things go I had many things to do around the house and installing ground rods was low on the list.  Well, September was here and I did not want to wait any longer and the decision was made to pound in two ground rods.
I did some online searching for ways to install ground rods and one way was to rent a tool that basically pounds them in. It's like a concrete hammer drill but for ground rods. I contacted the local building store who rented them and I was told for 1/2 day it was about 250.00!!!! Well, it first was time for plan B to see how that worked out. Plan B was to put the ground rods in on my own steam! Online there were many videos of folks who lifted the ground rod and slammed it into the ground. They kept doing this and added water into the hole as they went along. When the ground rod was close to the surface they used a hammer for the rest.  Another common thread in the videos was best case was to do this job after a few days of rain as this also helped out. As plans would have it did rain here for a few days and just after the rain I thought "It's a nice day to pound some ground rods in". Out I went with my trusty water bottles, work gloves and lots of ambition. I have to say the first ground rod at the base of my Hustler 4BTV went in very easily. So bubbling with confidence I moved to the second location which was for a ground rod that was to ground my station.
This spot was not as smooth going, the first attempt came to an abrupt stop at about the 4-foot mark. The only thing I could figure was I hit a tree root from one of our Maple trees. The second attempt was a charm BUT it was not easy going. I added water and slammed the ground rod down and it did go in but very very very slowly. Finally, success and both ground rods were in and connected to the antenna and the other to a ground bus in my shack.

 

We're back!

Read in over 150 countries, we bring you 125+ pages of Amateur Radio content from the Southwest corner of Canada and elsewhere. With less fluff and ads than other Amateur Radio publications, you will find Amateur Radio related articles, projects, profiles, news, tips and how-to's for all levels of the hobby.

You can view or download it as a .PDF file:  

Previous Communicator issues:

Search for past Communicator issues

and a full index is HERE.  

As always, thank you to our contributors, and your feedback is always welcome. 

The deadline for the next edition is October 15th and we're especially looking for articles and stories about 3D printing for amateur radio.

If you have news or events from your club or photos, stories, projects or other items of interest from BC or elsewhere, please contact us at [email protected]

73,

John VE7TI
'The Communicator' Editor

Ham College episode 116 is now available for download.

Ham College 116
Technician Exam Questions Part 3.
T1C – Licensing: classes, sequential and vanity call sign systems, places where the Amateur Radio Service is regulated by the FCC, name and address on FCC license database, term, renewal, grace period, maintaining mailing address; International communications
Early radio receivers.

Download
YouTube

Hello and welcome to Epiosde 553 of Linux in the Ham Shack. In this short topics episode, the hosts discuss the recent troubles and resolutions at the ARRL, a RISC-V tablet that runs Ubuntu, the new version of LibreOffice, a Microsoft flaw that breaks things (shocker), and much more. Thanks for listening and have a great week.

73 de The LHS Crew