LHS Episode #508: Close Enough
Welcome to the 508th installment of Linux in the Ham Shack. In this short topics episode, the hosts discuss several topics including: the ARDC on groups.io, changes to HOA rules for hams, potential licensing changes in the UK, Intel's Mono font, KDE, Not1MM and much more. Thanks for listening and have a great week.
73 de The LHS Crew
Russ Woodman, K5TUX, co-hosts the Linux in the Ham Shack podcast which is available for download in both MP3 and OGG audio format. Contact him at [email protected].
Field Day with 4 AA Batteries
This year’s Field Day provided a chance to experiment with emergency communications. I used a tiny rig that fits in a 3 X 5 inch box and runs on 4 AA batteries. I set out to work 50 stations with this setup. I succeeded.
This box fits is a shirt pocket. It contains the MTR-3, earphones, adapters for power and antenna, the paddles, and an extension for the paddles. It does not contain an antenna or batteries.
For power I used 4 AA batteries in the Goal Zero Guide 12 power bank. It outputs 5 volts to a USB-A connector. I converted that to 10.3 volts with the Baofeng USB charging adapter.
I wanted to put this kit together for years. I was never able to find paddles that were small enough to fit. Then I found the N6ARA paddles. They are smaller than your little finger. They can plug directly into the key input. I used a short extension and held the paddles in my left hand and keyed with my right hand.
I put up an 88 foot doublet for the event and planned to operate 1B on the deck. Then it rained. I operated from the sun room as 1E on 40 and 20 meters. I made the 50 QSOs fairly quickly. I would guess my setup was putting out about 3 watts. The batteries would have been good for another 5 hours I think.
Then I switched to the (tr) uSDX rig running 5 watts. I wasn’t sure if it would stand up to Field Day traffic. It did wonderfully. I made another 50 QSOs with that tiny rig. I used a set of full sized paddles with three 18650 batteries for a full 12 volts.
Field Day provides a great opportunity to test emergency gear. These experiments satisfied me that pocket gear, with a modest antenna and a USB power bank will do quite well in a pinch.
Jim Cluett, W1PID, is a regular contributor to AmateurRadio.com and writes from New Hampshire, USA. Contact him at [email protected].
Taking things for granted
Before I start this post, I want to dispel any rumors that all W2LJ does at Field Day is take photographs. Here are two of yours truly actually pounding brass and adding points to the NJ2SP Field Day total - courtesy of Mario KD2HPF.
Field Day, or perhaps better said, the end of Field Day often causes me to wax nostalgic. That definitely happened this year, and a large part of it was seen in that video which I posted yesterday. Watching Marv K2VHW working ZL4TT in New Zealand brought back me back, in an instant, to something that happened to me, as a newly licensed Amateur Radio operator so many years ago.
A little context - Bill W2AOF, our Club President, spent a month with friends in New Zealand earlier this year. When he got back, he filled us in on the details of the trip. He had a great time, got to see a lot of wonderful sights, got to eat good food and spend quality time with good people. Yet, there was a price to pay, and I'm not referring to the monetary expense. Sure, there was that, but there was also an expenditure of time.
With all the technological advancements we've witnessed over the last century, getting to New Zealand from New Jersey is comparatively easy compared to 100 years ago. Back then, the ocean voyage took weeks. Flying by air is a snap compared to that, but even that takes time. You don't often think about it, but even flying on a commercial aircraft, going at speeds never dreamt of by the seafaring ships of the old days, it still takes the better part of a day (around 18 hours) to get from New Jersey to New Zealand. And in the middle of the overnight, in the wee hours of Sunday morning, with 5 Watts of power to a hunk of wire hanging in the air, we made that trip and back in seconds, the whole conversation taking a few minutes!
I was struck by that, once again. I wish Bill had been there. He had left a few hours earlier to make sure the A/C was working properly in his home as well as to get some much needed rest. Had he been there. Bill is the kind of guy who would have been taken aback and would have experienced that "Wow factor" of what had just been accomplished. We communicate with all parts of the world. There is really no place too far that our radio waves can't reach. But how often do we let that soak in? How often do we get annoyed when that DX contact isn't made. How often do we take our radios and our hobby and all the physics involved for granted?
I guess I'm one of the lucky ones, as I had a similar experience happen to me back in 1979, and I'm sure it's been related somewhere earlier in this blog. But I like to think about it, it's an enjoyable memory and I'll re-tell it again.
I passed my Novice exam sometime back in October/November of 1978. The actual paper "ticket" came in the mail the last week of the year. I didn't even get on the air until the end of January of 1979, as I was busy putting my station together, and building my Heathkit Novice receiver kit that I had gotten as a Christmas gift. I upgraded to General in July and I worked my first DX contact with a Ham in Germany shortly thereafter.
Later that year in October of 1979, my best friend and I decided to take a trip up to the White Mountains in New Hampshire to do some photography. We were two young budding photographers who were working together at a local camera shop and we both needed a road trip. We got our much needed time off and eventually made it all the way to Maine, specifically Bar Harbor. From there we decided that we would follow the coast as we made our way back to New Jersey.
That meant a side trip to Cape Cod, and on the way out to Provincetown for some authentic New England clam chowder we came across a sign indicating that we were approaching the site of Marconi's Wellfleet Station. I had to stop. We were in my car and I was the driver, so what I say goes .....goes. Right? What newly minted Amateur Radio operator would not want to visit a Marconi site?
Not my image, but this is what you see when you visit. ^ This site is part of the National Park's Cape Cod National Seashore entity, so it is well maintained and there is a plethora of history to read about. This is what it looked like back in the day:
A few of the cement pylons that anchored the legs of the antenna towers were still there when I visited. Most had washed away into the sea as a result of beach erosion.
But it was the sea that struck me the most, which is a strange thing to say as I was born, bred and continue to live in New Jersey. I've seen the Atlantic Ocean and it bays hundreds, if not close to a thousand times in my time here on earth. But that time was different.
I had not yet traveled to Switzerland, and would not experience air travel to Europe for another nine years, but standing there, for a VERY long time, where history had been made, just staring at the ocean, looking out upon all that water as far as my eye could see, was an experience unlike any other I had ever had. All I could think of was the radio waves from my Drake 2-NT and my MorGain multiband dipole, flying over all that water to another Ham in Germany. And her radio waves (she was an XYL) travelling back to my Heathkit HR-1680 receiver in a matter of seconds.
That water looked like it would never end. I knew that it did. I knew that on the other side of that vastness was Europe and the rest of the world. To contemplate my radio signals covering all that distance made me feel so tiny, but also filled me with awe at the immensity of Creation at the same time.
We get so busy on Field Day and the rest of the year with making contacts, conducting ragchews, running nets, competing in contests, speaking into microphones, banging away on keys, typing away on keyboards that we forget to notice what is really happening. It's the magical part of Amateur Radio that never grows old for me and I hope I never take it for granted.
Long winded, I know, but thanks for staying with me!
72 de Larry W2LJ
QRP - When you care to send the very least!
Larry Makoski, W2LJ, is a regular contributor to AmateurRadio.com and writes from New Jersey, USA. Contact him at [email protected].
About That UHF Connector
I caused a minor kerfuffle on Twitter recently, when I posted this:
This connector, properly called a PL-259, is the most common RF connector for ham radio use. The female counterpart is called the SO-239 connector. While these connectors are often “UHF” connectors, they actually don’t perform very well at those frequencies (300 to 3000 MHz). So I feel justified in disparaging that name.
The tweet generated a large number of replies, mostly in support of my anti-UHF-naming sentiment. It seems that other highly-educated and thoughtful radio amateurs agree with me. (It seems that the wise hams out there always agree with me.) You should be able to view the thread here: https://twitter.com/K0NR/status/1653575723838492672
Some people pushed back on the anti-UHF sentiment, usually saying that it is the common name for this connecter. A few folks pointed out that Amphenol calls these things “UHF Connectors”, which did surprise me. Who am I to disagree with this manufacturer of high-quality connectors? Of course, Amphenol also says this:
Originally intended for use as a video connector in radar applications, UHF coaxial connectors are general purpose units developed for use in low frequency systems from 0.6 – 300 MHz. Invented for use in the radio industry in the 1930’s, UHF is an acronym for Ultra High Frequency because at the time 300 MHz was considered high frequency. They can be used when impedance mating is not required.
Well, there you have it: the connector was named UHF back when UHF meant up to 300 MHz. (Today, UHF means 300 to 3000 MHz). I particularly like the comment “They can be used when impedance mating is not required.” What? That does not sound good for RF applications. I do agree that these connectors can generally be used to 300 MHz, but these days the ITU calls that VHF (30 to 300 MHz).
Wikipedia provides a more complete explanation, worth reading.
OK, so the name “UHF” is archaic but it has kind of stuck, the way old terminology sometimes does. I am still going to avoid using this term because it really should be deprecated.
And don’t use these connectors above 300 MHz (UHF frequencies). Unless you have to. Which I did last weekend when the only cable available for my 440 MHz antenna had a PL-259 connector on it.
73 Bob K0NR
The post About That UHF Connector appeared first on The KØNR Radio Site.
Bob Witte, KØNR, is a regular contributor to AmateurRadio.com and writes from Colorado, USA. Contact him at [email protected].
ICQ Podcast Episode 406 – UK Amateur Radio Licence Proposed Changes
In this episode, we discuss the recently released proposed changes to the UK Amateur Radio Licence with RSGB Chairman John McCullagh GI4BWM, President Stewart Bryant G3YSX and General Manager Steve Thomas M1ACB.
We would like to thank our monthly and annual subscription donors for keeping the podcast advert free. To donate, please visit - http://www.icqpodcast.com/donate
Colin Butler, M6BOY, is the host of the ICQ Podcast, a weekly radio show about Amateur Radio. Contact him at [email protected].
Amateur Radio Weekly – Issue 291
This weekend is Field Day
Find an event happening near you.
ARRL
13 Colonies special event begins July 1
Event runs from July 1 through July 8 and consists of 13 colony stations and 2 bonus stations.
13 Colonies
Ofcom proposes multitude of changes to licensing framework
Changes include additional access to spectrum and airborne use.
Amateur Radio Daily
Report sheds some light on Icom’s Amateur Radio strategy
The report paints a picture of what Icom’s business strategy will be over the next three years.
KB6NU
Amateur Radio Moonshots
The 5 things that show the most promise in revolutionizing Amateur Radio.
Zero Retries
Cornbread Road: An episodic Ham Radio mystery
Thirteen episodes originally released once per week from the summer solstice until the autumnal equinox.
KE9V
Amateur Radio helps air show fly high
Middle Tennessee radio clubs partnered to provide operations support throughout the 2023 Great Tennessee Air Show.
ARRL
My father may be gone, but our radio is still going
My most prized possession was once somebody’s trash.
Los Angeles Times
How to take advantage of ARRL log archives
The original logs from the 1977 KA1S operation were indeed on file.
OnAllBands
Modding the Quansheng UV-K5 HT
A collection of modified firmwares for the Quansheng UV-K5 radio.
Tunas1337
The NVIS illusion
I don’t think there is any subject that is so misunderstood by hams as NVIS.
Ham Radio Outside the Box
Get in over your head
Starting off on something that you don’t already know how to do provides you with a fearlessness.
Hackaday
Video
Ham Radio enthusiast’s long road since the Derecho
Tower collapse and community to the rescue.
WBRC
Get Amateur Radio Weekly in your inbox.
Sign-up here
Amateur Radio Weekly is curated by Cale Mooth K4HCK. Sign up free to receive ham radio's most relevant news, projects, technology and events by e-mail each week at http://www.hamweekly.com.
ICQ Podcast Episode 405 – CW Innovations
In this episode, we join Martin Butler M1MRB, Dan Romanchik KB6NU, Caryn Eve Murray KD2GUT and Edmund Spicer M0MNG to discuss the latest Amateur / Ham Radio news. Colin Butler (M6BOY) rounds up the news in brief and in the episode's feature is CW Innovations.
We would like to thank our monthly and annual subscription donors for keeping the podcast advert free. To donate, please visit - http://www.icqpodcast.com/donate
- Distance Learning for Full Licence Exam - Young Dxpeditioners Plan for Guyana Trip - WRTC To Go Forward in Italy Despite Floods - CW OP Who Copied Titanic Signal Fan Page - Take Your Own Photos From Space? - King Hussein UK Radio Shack Donated to RSGB - 2023 ARRL Field Day
Colin Butler, M6BOY, is the host of the ICQ Podcast, a weekly radio show about Amateur Radio. Contact him at [email protected].