AmateurRadio.com

This week has been dedicated to setting up for the CQ WW DX CW contest this weekend. Making sure the contest logger works (N1MM), try out the CW macros along with the K3, test out the antenna on all the bands and finally make up some goals. I find by doing some prep work before the contest Murphy does not rear his head as often during the contest. Early last week my Tigertronics Signalink USB came in and it was my ticket to get into the digital world. Years ago I had a Yaesu  FT-1000MP MKV I had the Rigblaster Pro along side it. I dabbled in PSK and was into RTTY contesting at that time. I had hopes of setting things up and getting on the surf board of Digital communications last weekend.
Well that dream was short lived, the memories came back of sound card setup, adjusting the ALC level and basically getting everything just right for the digital engine to purrrr. Over the weekend the setup was not purrrring at all it was more of a hisssssss.  The connections between my K3 and Signalink were smooth going. The PC recognized the on board sound card in the Signalink. At first I ran into some trouble setting up the CAT connection between the K3 and software  (Ham radio delux's digital master 780) I was able to decode PSK signals with Digital Master, in transmit with the K3 set at 100 watts I was able to use the TX control on the Signalink to raise the output power to what I wanted (5 watts). The unresolved problem is I am not able to get any ALC reading on the K3. I know the ALC is very important to a clean signal. I have given up trying to solve this problem at this time. I am as I said concentrating on the CQ WW DX CW contest.